Overview of Screens Chore-Tronics® 2 Control
34
MT1843B
(History) Reset History-Environment Screen
To access the Reset History "Reset History-Environment Screen", press the Tab Key
under "Reset". This screen is where the user can tell the control to erase all of the
current environment history data stored in the control. Answer "YES or "NO" to "Are
you sure to reset the history".
Screen 8: Alarms
The Alarms Screen consists of the Alarm Overview, Alarm Settings, and Alarm
History Screen. The Indicator Light (LED) next to the number 8 Subject Button
indicates the current status of the Alarm. The Alarm Status’s are as follows...
1. Solid Green- All is normal (No Alarm)
2. Flashing Green- Warning, un-noticed alarm, or temporary off alarm
3. Flashing Red- Active Alarm
(Alarms Screen) Overview Tab
To access the Alarms "Overview screen", press the Tab Key under "Overview". This
Screen is the list of all currently active or recovered, but not noticed alarms. In Figure
38 below, a "Min. Temp Alarm" has occurred and recovered. This alarm message
will remain listed in this screen until it is recovered. To notice the alarm first press
the edit button. Highlight the RECOV field and use the +/- keys to change the status
to NOTICE, then press the Enter key. This should remove the alarm from the list.
MT1842-074 10/04
1
YES
Figure 37. History Screen: Reset History-Environment Tab
MT1842-073 10/04
1
MT1842-018 10/04
Figure 38. Alarms Screen: Overview Tab
Or
1
1. Status-This is the current status of the
alarm system. The three possible sta-
tuses are ACTIVE, DISABLED, AND
TEST. The status field is editable.
To Next Page
Loading...
Need help?
General