Overview of Screens Chore-Tronics® 2 Control
52
MT1843B
Setup-Control Screen Outputs Ventilation Control Tab
To access the Setup-Control "Outputs Ventilation Control Screen, press the Tab Key
under "Outp. Vent".
1. Minimum number of tunnel fans on-Enter the minimum number of fans to be
running in Tunnel mode here. For further information see the Control Operation
Overview section of this manual.
2. Cool Outputs-If there are relays assigned to cool output(s), and a relative
humidity sensor is connected to the Control, the Control can block the cool out-
put from turning on if the relative humidity sensor reading is higher than entered
value. The user can also specify a specific time of day in which the cool outputs
are allowed to operate. A setting of 12:00a to 12:00a means that the cool outputs
are allowed to operated 24 hours per day.
3. Cool Pad Settings-If the optional cool pad function is used, the parameters and
settings for the cool pad function are entered here. For additional information on
the cool pad settings please see the Control Operation Overview section of this
manual.
MT1842-052 10/04
Figure 66. Setup-Control Screen: Outputs Vent. Control Tab
1
2
3
To Next Page
Loading...