Remote Operation
ADV:OCP:SPEC:L 500mA Set low level current = 0.5A.
ADV:OCP:SPEC:L MAX Set low level current = maximum
value.
ADV:OCP:SPEC:L MIN Set low level current = minimum value.
Query Syntax: ADVance:OCP:SPECification:L?[<space><MAX | MIN>]
Return Parameters:<NR2>, [Unit = Ampere]
Query Example: ADV:OCP:SPEC:L?
ADV:OCP:SPEC:L? MAX
ADV:OCP:SPEC:L? MIN
ADVance:OCP:STEP
Type: Channel-Specific
Description: Set step count for OCP test mode.
Setting Syntax: ADVance:OCP:STEP<space><NRf+>
Setting Parameters:<NRf+>, 1 ~ 1000, Resolution = 1, Unit = None
Setting Example: ADV:OCP:STEP 500 Set step count = 500.
ADV:OCP:STEP MAX Set step count = maximum value.
ADV:OCP:STEP MIN Set step count = minimum value.
Query Syntax: ADVance:OCP:STEP?[<space><MAX | MIN>]
Return Parameters:<NR1>, [Unit = None]
Query Example: ADV:OCP:STEP?
ADV:OCP:STEP? MAX
ADV:OCP:STEP? MIN
ADVance:OCP:TRIGger:VOLTage
Type: Channel-Specific
Description: Set trigger voltage for OCP test mode.
Setting Syntax: ADVance:OCP:TRIGger:VOLTage<space><NRf+>[suffix]
Setting Parameters:Refer to respective specification for valid value range.
Setting Example: ADV:OCP:TRIG:VOLT 0.5 Set trigger voltage = 0.5V.
ADV:OCP:TRIG:VOLT 500mV Set trigger voltage = 0.5V.
ADV:OCP:TRIG:VOLT MAX Set trigger voltage = maximum
value.
ADV:OCP:TRIG:VOLT MIN Set trigger voltage = minimum
value.
Query Syntax: ADVance:OCP:TRIGger:VOLTage?[<space><MAX | MIN>]
Return Parameters:<NR2>, [Unit = Volt]
Query Example: ADV:OCP:TRIG:VOLT?
ADV:OCP:TRIG:VOLT? MAX
ADV:OCP:TRIG:VOLT? MIN
ADVance:OCP:LACTh
Type: Channel-Specific
Description: Set load latch function for OCP test mode.
Setting Syntax: ADVance:OCP:LATCh<space><CRD | NR1>
Setting Parameters:<CRD | NR1>, OFF(0), ON(1)
Setting Example: ADV:OCP:LATC OFF Set latch = OFF
ADV:OCP:LATC 1 Set latch = ON
Query Syntax: ADVance:OCP:LATCh?
Return Parameters:<CRD>, OFF, ON [Unit = None]
Query Example: ADV:OCP:LATC?
To Next Page
Loading...
Need help?
General
