Chroma 63600 Series User Manual

Programmable DC Electronic Load 63600 Series Operation & Programming Manual
5-32
ADVance:TIMing:ENDVoltage
Type: Channel-Specific
Description: Set end voltage when trigger mode set to HOLD_UP for Timing
mode.
Setting Syntax: ADVance:TIMing:ENDVoltage<space><NRf+>[suffix]
Setting Parameters:Refer to respective specification for valid value range.
Setting Example: ADV:TIM:ENDV 0.5 Set end voltage = 0.5V
ADV:TIM:ENDV 500mV Set end voltage = 0.5V
ADV:TIM:ENDV MAX Set end voltage = maximum value.
ADV:TIM:ENDV MIN Set end voltage = minimum value.
Query Syntax: ADVance:TIMing:ENDVoltage?[<space><MAX | MIN>]
Return Parameters:<NR2>, [Unit = Volt]
Query Example: ADV:TIM:ENDV?
ADV:TIM:ENDV? MAX
ADV:TIM:ENDV? MIN
ADVance:TIMing:FALL
Type: Channel-Specific
Description: Set falling slew rate of current in Timing mode.
Setting Syntax: ADVance:TIMing:FALL<space><NRf+>[suffix]
Setting Parameters:Refer to respective specification for valid value range.
Setting Example: ADV:TIM:FALL 0.1 Set slew rate = 0.1A/μs
ADV:TIM:FALL 100mA/μs Set slew rate = 0.1A/μs
ADV:TIM:FALL MAX Set slew rate = maximum value.
ADV:TIM:FALL MIN Set slew rate = minimum value.
Query Syntax: ADVance:TIMing:FALL?[<space><MAX | MIN>]
Return Parameters:<NR2>, [Unit = A/uS]
Query Example: ADV:TIM:FALL?
ADV:TIM:FALL? MAX
ADV:TIM:FALL? MIN
ADVance:TIMing:MODE
Type: Channel-Specific
Description: Set run mode in Timing mode.
Setting Syntax: ADVance:TIMing:MODE<space><CRD | NR1>
Setting Parameters:<CRD | NR1>, CC(0), CR(1), CP(2)
Setting Example: ADV:TIM:MODE CR Set run mode = CR mode
ADV:TIM:MODE 1 Set run mode = CR mode
Query Syntax: ADVance:TIMing:MODE?
Return Parameters:<CRD>, CC, CR, CP [Unit = None]
Query Example: ADV:TIM:MODE?
ADVance:TIMing:RISE
Type: Channel-Specific
Description: Set rising slew rate of current in Timing mode.
Setting Syntax: ADVance:TIMing:RISE<space><NRf+>[suffix]
Setting Parameters:Refer to respective specification for valid value range.
Setting Example: ADV:TIM:RISE 0.1 Set slew rate = 0.1A/μs
ADV:TIM:RISE 100mA/μs Set slew rate = 0.1A/μs
ADV:TIM:RISE MAX Set slew rate = maximum value.
ADV:TIM:RISE MIN Set slew rate = minimum value.
Query Syntax: ADVance:TIMing:RISE?[<space><MAX | MIN>]
Return Parameters:<NR2>, [Unit = A/uS]

Chroma 63600 Series Specifications

General

Series	63600
Operating Temperature	0°C to 40°C
Modes	CC, CV
Interface	GPIB, USB
Protection	OCP, OTP, OVP
Voltage Resolution	1mV
Cooling	Forced Air