Chrysler Dodge Caravan 2002 - DOOR - FRONT; APPLIQUE; REMOVAL; INSTALLATION

DOOR - FRONT
TABLE OF CONTENTS
page page
APPLIQUE
REMOVAL .............................14
INSTALLATION .........................14
CHECK STRAP
REMOVAL .............................14
INSTALLATION .........................14
DOOR
REMOVAL .............................15
INSTALLATION .........................16
DOOR GLASS
REMOVAL .............................16
INSTALLATION .........................17
FRAME CLOSEOUT MOLDING
REMOVAL – A-PILLAR, HEADER, OR
B-PILLAR ............................17
INSTALLATION – A-PILLAR, HEADER, OR
B-PILLAR ............................17
HINGE
REMOVAL .............................18
INSTALLATION .........................18
LATCH
REMOVAL .............................18
INSTALLATION .........................18
LATCH STRIKER
REMOVAL .............................19
INSTALLATION .........................19
LOCK CYLINDER
REMOVAL .............................19
INSTALLATION .........................20
TRIM PANEL
REMOVAL .............................20
INSTALLATION .........................21
WATERSHIELD
REMOVAL .............................21
INSTALLATION .........................21
WINDOW CRANK
REMOVAL .............................21
INSTALLATION .........................21
WINDOW REGULATOR
REMOVAL .............................22
INSTALLATION .........................22
EXTERIOR HANDLE
REMOVAL .............................23
INSTALLATION .........................23
APPLIQUE
REMOVAL
(1) Roll door glass down.
(2) Remove outer door belt molding.
(3) Disengage clips holding front edge of applique
to door frame.
(4) Remove applique from vehicle (Fig. 1).
INSTALLATION
(1) Position applique on vehicle.
(2) Hook rear edge of applique over rear edge of
door frame and seat applique bottom edge on sheet
metal.
(3) Engage clips to hold front edge of applique to
door frame.
(4) Install outer door belt molding.
CHECK STRAP
REMOVAL
(1) Remove front door trim panel.
(2) Remove front door watershield (Refer to 23 -
BODY/DOOR - FRONT/WATERSHIELD - REMOV-
AL).
(3) Remove front door speaker, if equipped.
(4) Remove bolts attaching door check strap to
A-pillar.
(5) Remove nuts attaching check strap to door end
frame (Fig. 2).
(6) Remove check strap from door through speaker
hole.
INSTALLATION
(1) Position check strap on door through speaker
hole.
(2) Install nuts to attach check strap to door end
frame. Tighten nuts to 11 N·m (90 in. lbs.) torque.
(3) Install bolts to attach check strap to A-pillar.
Tighten bolts to 12 N·m (105 in. lbs.) torque.
(4) Install door speaker, if equipped.
(5) Install front door trim panel.
23 - 14 DOOR - FRONT RS