CipherLab RS30 - Page 167

153
2D Imager (SE4500DL)
Length option Sets the length of the Code 93 symbols to decode.
One Fixed length (Length 1)
Two Fixed lengths (Length 1>Length 2)
Max / Min Length (range: 0-55; Length 1<Length 2)
Any Length
Max / Min
Length
(4-55)
CODE 128
Code 128 Enable
Code 128 Switch to enable Code 128 decoding. Enable
GS1-128 Enable
GS1-128 Switch to enable GS1-128 decoding. Enable
Separator Character Enable the function code character separator, which is used
to separate data fields of
variable length and application
identifiers
of subsequent data fields in concatenated data
strings. Tap the keyboard icon to open
a mapping table for
selecting a separator character to replace with.
None
ISBT-128 Enable
ISBT 128 Switch to enable ISBT 128 decoding. Enable
Concatenation Sets whether to enable decoding ISBT-
128 by performing
concatenation of ISBT data
Disable: Does not perform concatenation
Enable: Performs concatenation on all ISBT-128 barcodes.
Auto-discriminate: Auto-discriminates between the ISBT-128
barcodes which require concatenation and those which do not need
concatenation.
Auto-discrimi
nate
Redundancy When “Auto-
discriminate” is applied, decide the number of
times of supplementary decoding the same barcode to count
as a valid read. Configurable between 2 and 20
10
CODE 2 OF 5
Chinese 25 Enable
Chinese 25 Switch to enable Chinese 2 of 5 decoding. Enable
Discrete 25 Enable
Discrete 25 Switch to enable Discrete 2 of 5 decoding. Enable