CipherLab RS30 - Page 169

155
2D Imager (SE4500DL)
Composite CC-C Enable
Composite CC-C Switch to enable Composite CC-C decoding. Enable
Composite TLC 39 Disable
Composite TLC 39 Switch to enable Composite TLC 39 decoding. Disable
Composite General Preference
UPC Composite Mode
UPC barcodes can be "linked" with a 2D barcode during
transmission as if they were one barcode.
UPC Never Linked
Transmit UPC barcodes
regardless of whether a 2D
barcode is detected.
UPC Always Linked
Transmit UPC barcodes and the 2D portion. If the 2D
portion is not detected, the UPC barcode will not be
transmitted.
CC-A/B or CC-C must be enabled.
Auto-discriminate
Transmit UPC
barcodes as well as the 2D portion if
present.
UPC always
Linked
GS1-128 Emulation
Mode
Sets GS1-
128 emulation mode for UCC/EAN Composite
Codes.
Disable
GS1 DATABAR
GS1 DataBar-14 Enable
GS1 DataBar-14 Switch to enable GS1 DataBar-14 decoding. Enable
Convert to UPC/EAN Strips the leading ‘010’ of GS1
DataBar and converts the
barcode to EAN-13.
Disable
GS1 DataBar Limited Enable
GS1 DataBar Limited Switch to enable GS1 DataBar Limited decoding. Enable
Convert to UPC/EAN Strips the leading ‘010’ of GS1 DataBar Limited and converts
the barcode to EAN-13.
Disable
Security Level There are setting options from Level 1 to 4. Level 3
GS1 DataBar Expanded Enable
GS1 DataBar Expanded Switch to enable GS1 DataBar Expanded decoding. Enable
Separator Character Enable the function code character separator, which is used
to separate data fields of
variable length and application
identifiers
of subsequent data fields in concatenated data
strings.
None
KOREAN 3 OF 5