Circutor CVM-C10 - Page 39

Table 9 (Continuation) : Analyzer profile screens.
Screen Parameters (units)
Power factor L1 (PF)
Power factor L2 (PF)
Power factor L3 (PF)
Power factor III (PF)
Cos φ L1 (cos φ)
Cos φ L2 (cos φ)
Cos φ L3 (cos φ)
Cos φ III (cos φ)
Also displayed on these screens are:
 Maximum values
To see the maximum values of the screen being displayed, press the
key for 2
seconds. These are displayed for 30 seconds.
The max symbol is shown on the display (Figure 27)
The maximum and minimum values are reset on the programming menu.
(“4.9.15. Deleting maximum and minimum values”)
Figure 27: Analyzer prole screen displaying the maximum values.
 Minimum values
To see the minimum values of the screen being displayed, press the
key for 2
seconds. These are displayed for 30 seconds.
The min symbol will be displayed (Figure 28)
The maximum and minimum values are reset on the programming menu.
(
“4.9.15. Deleting maximum and minimum values”)
39
Instruction Manual
CVM-C10