On this screen you enter the password for locking and unlocking
the programming.
Press key
for 3 seconds to edit the password selection. The
prog icon will be displayed on the bottom of the screen.
To enter or modify the value, press the
key repeatedly,
increasing the value of the ashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key
to modify the other values.
If you press the
key after changing the last digit, it will jump back to the rst digit so you
can modify the previously programmed values again.
To validate the data, press
for 3 seconds and the prog icon will disappear from the display.
Default password: 1234.
This value may only be modified through communications. See “4.10.3.6.17. Password
conguration.”
Press the key to exit the setup menu.
Note: The device will restart after exiting the setup menu if the RS-485 communications
parameters have been modied.
71
To Next Page
Loading...
Need help?
General
