Cirris 4200 - 21 Legacy Defaults

42
Cirris 4200 Series User Manual
21. Legacy Defaults
On legacy CIrris testers such as the 1100 Series, test preferences, settings, reports, and digital I/O were controlled on a
tester level. This means changes aected all test programs globally. On the 4200 Series, settings are controlled on a test-
by-test basis. If you change one test program, it has no eect on other test programs.
To use test programs from a legacy tester, set the Legacy Defaults on your 4200 Series tester to match the system settings
of your legacy Cirris tester.
Once a legacy test program has been edited and saved on a 4200 Series tester, the new test-level settings will be applied.
The same test program can still beused on an legacy Cirris tester with the legacy tester applying its own system settings.