Cirris 4200 - Wi-Fi; Connecting to Cirris Hub

44
Cirris 4200 Series User Manual
22.2 Wi-Fi
Warning: When using Wi-Fi, you may on occasion notice the tester pause to reestablish network communication. Cirris
recommends using a wired connection.
1. On the Network Settings screen:
● Mode: WiFi
● SSID: Press Refresh then select the wireless network from the dropdown list.
Note: The name of the wireless network must be broadcast. The tester is not capable of connecting to a non-broadcast
wireless network.
● Auth Mode: Select Enterprise or Pre-shared Key depending on your network environment.
● Username: Enter the Username if using the Enterprise mode.
● Password: Enter the password to connect to the network.
● Server: Server: IP address for the computer running Cirris Hub Software.
○ The tester will automatically dtetct the IP address of the computer running Cirris Hub Software If the tester is on
the same subnet.
○ Enter the IP address or host name of the computer running Cirris Hub Software if the network service is not de-
tected.
● Port: You do not have to enter a port if the tester automatically detects the Cirris Hub Server on its subnet. The de-
fault port is 12568 or enter the port number as set up by the IT administrator.
● If a client CA Certicate is required, insert a USB drive containing the certicate into the USB port on the back of the
tester. Press Add CA Cert to access the certicate.
2. Press Done. The tester should say Connecting to the Hub then return to the System Settings screen. When you load a
test from the Main Menu, you will notice that you can select F: drive.
Your tester should now appear on the list of available testers in Cirris Hub Software. See the Cirris Hub Software Installation
Guide for more information.
22.2.1 Connecting to Cirris Hub...
Depending on your environment, network, and other conditions, you
may experience occasional pauses when using Wi-Fi. These pauses
can last several seconds while a window blocks the tester screen. Do
not press cancel. Wait for the tester to connect to the network. Once
the tester reconnects, the window will disappear and the test process
can resume.
Network Settings
Connecting to Cirris Hub...
Initializing ...
Cancel