Cirrus DESIGN SR22T User Manual

3A-6 P/N 13772-003
Section 3A Cirrus Design
Abnormal Procedures SR22T
Abnormal Landings
Landing With Failed Brakes
One brake inoperative
1. Land on the side of runway corresponding to the inoperative
brake.
2. Maintain directional control using rudder and working brake.
Both brakes inoperative
1. Divert to the longest, widest runway with the most direct
headwind.
2. Land on downwind side of the runway.
3. Use the rudder for obstacle avoidance.
4. Perform Emergency Engine Shutdown on Ground checklist.
Amplification
Rudder effectiveness will decrease with decreasing airspeed.
Landing With Flat Tire
Main Gear
1. Land on the side of the runway corresponding to the good tire.
2. Maintain directional control with the brakes and rudder.
3. Do not taxi. Stop the airplane and perform a normal engine
shutdown.
Nose Gear
1. Land in the center of the runway.
2. Hold the nosewheel off the ground as long as possible.
3. Do not taxi. Stop the airplane and perform a normal engine
shutdown.
Amplification
If a flat tire or tread separation occurs during takeoff and you cannot
abort, land as soon as conditions permit.
Revision 1

Cirrus DESIGN SR22T Specifications

General

Manufacturer	Cirrus Aircraft
Model	SR22T
Seating Capacity	5
Engine	Continental TSIO-550-K
Horsepower	315 hp
Avionics	Cirrus Perspective+ by Garmin
Type	Single-engine piston aircraft
Maximum Speed	213 knots
Cruise Speed	183 knots
Service Ceiling	25, 000 feet
Maximum Takeoff Weight	3, 600 lbs
Wingspan	38 feet 4 inches
Length	26 ft
Height	8 feet 11 inches
Safety Features	Cirrus Airframe Parachute System (CAPS)
Cabin Width	49 inches
Cabin Height	50 inches