Cirrus Design Section 7
SR22T Airplane and Systems Description
P/N 13772-003 7-27
Seats
The seating arrangement consists of two individually adjustable seats
for the pilot and front seat passenger and two individual seats with fold
down seat backs for the rear seat passengers.The front seats are
adjustable fore and aft and the seat backs can be reclined for
passenger comfort or folded forward for rear seat access. Integral
headrests are provided. The fore and aft travel path is adjusted
through the seat position control located below the forward edge of the
seat cushion. The seat track is angled upward for forward travel so that
shorter people will be positioned slightly higher as they adjust the seat
forward. Recline position is controlled through levers located on each
side of the seat backs. Depressing the recline release control while
there is no pressure on the seat back will return the seat back to the
full up position.
• Caution •
Do not kneel or stand on the seats. The seat bottoms have an
integral aluminum honeycomb core designed to crush under
impact to absorb downward loads.
To position front seat fore and aft:
1. Lift the position control handle.
2. Slide the seat into position.
3. Release the handle and check that the seat is locked in place.
To adjust recline position:
1. Actuate and hold the seat back control lever.
2. Position the seat back to the desired angle.
3. Release the control lever.
Each rear seat consists of a fixed seat bottom, a folding seat back, and
a headrest. The seat backs can be unlatched from inside the baggage
compartment and folded forward to provide a semi-flat surface for
bulky cargo extending forward from the baggage compartment.
To fold seat back forward:
1. From the baggage access, lift the carpet panel at lower aft edge of
seat to reveal the seat back locking pins (attached to lanyards).
2. Remove the locking pins and fold seat forward.
Original Issue
To Next Page
Loading...
Need help?
General
