EasyManua.ls Logo

Cirrus DESIGN SR22T - Left;Right Brake Over-Temperature; Starter Engaged

Cirrus DESIGN SR22T
512 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-40 P/N 13772-003
Section 3 Cirrus Design
Emergency Procedures SR22T
Left/Right Brake Over-Temperature
BRAKE TEMP Warning
1. Stop aircraft and allow the brakes to cool.
Amplification
Annunciation indicates brake temperature is greater than 293°F. Refer
to Section 10 - Safety Information: Taxiing, Steering, and Braking
Practices for additional information
Starter Engaged
STARTER ENGAGED Warning
On-Ground
1. Ignition Switch ............................................................DISENGAGE
2. Battery Switches ............... Wait 1 minute before next start attempt
If starter does not disengage (relay or solenoid failure):
3. BAT 1 Switch ............................................................................OFF
4. Engine ........................................................................SHUTDOWN
5. STARTER Circuit breaker.......................................................PULL
In-Flight
1. Ignition Switch ...................................... Ensure not stuck in START
2. STARTER Circuit breaker.......................................................PULL
3. Flight ............................................................................ CONTINUE
Engine start will not be available at destination.
(Continued on following page)
BRAKE TEMP
START ENGAGE
Original Issue

Table of Contents

Related product manuals