EasyManua.ls Logo

Cirrus DESIGN SR22T - Emergency Ground Egress

Cirrus DESIGN SR22T
512 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cirrus Design Section 3
SR22T Emergency Procedures
P/N 13772-003 3-41
Amplification
• WARNING •
Use extreme caution after shutdown if STARTER circuit
breaker required pull (failed relay or solenoid). If breaker is
unknowingly or unintentionally reset, starter will instantly
engage if Battery 1 power is supplied; creating a hazard for
ground personnel.
Starter has been engaged for more than 15 seconds (starter limit is 20
seconds); if not manually engaged, such as during difficult start, this
annunciation may indicate a failure of the starter solenoid or a stuck
keyswitch.
Emergency Ground Egress
1. Engine........................................................................ SHUTDOWN
2. Seat belts ....................................................................... RELEASE
3. Airplane................................................................................... EXIT
Amplification
• WARNING •
While exiting the airplane, make sure evacuation path is clear
of other aircraft, spinning propellers, and other hazards.
If the engine is left running, set the Parking Brake prior to evacuating
the airplane.
If the doors cannot be opened, break out the windows with egress
hammer, located in the console between the front seats, and crawl
through the opening.
Original Issue

Table of Contents

Related product manuals