EasyManua.ls Logo

Cirrus DESIGN SR22T - Starter Engaged

Cirrus DESIGN SR22T
512 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3A-8 P/N 13772-003
Section 3A Cirrus Design
Abnormal Procedures SR22T
Starter Engaged
STARTER ENGAGED Caution
On-Ground
1. Ignition Switch ........................... DISENGAGE prior to 20 Seconds
2. Battery Switches ...........Wait 20 seconds before next start attempt
If starter does not disengage (relay or solenoid failure):
3. BAT 1 Switch ............................................................................OFF
4. Engine ........................................................................SHUTDOWN
5. STARTER Circuit breaker.......................................................PULL
In-Flight
1. Ignition Switch ...................................... Ensure not stuck in START
2. STARTER Circuit breaker.......................................................PULL
3. Flight ............................................................................ CONTINUE
Engine start will not be available at destination.
Amplification
• WARNING •
Use extreme caution after shutdown if STARTER circuit
breaker required pull (failed relay or solenoid). If breaker is
unknowingly or unintentionally reset, starter will instantly
engage if Battery 1 power is supplied; creating a hazard for
ground personnel.
Starter has been engaged for more than 15 seconds (starter limit is 20
seconds); if not manually engaged, such as during difficult start, this
annunciation may indicate a failure of the starter solenoid or a stuck
keyswitch.
START ENGAGE
Revision 1

Table of Contents

Related product manuals