Cirrus DESIGN SR22T - Before Takeoff

Cirrus Design Section 4
SR22T Normal Procedures
P/N 13772-003 4-13
Before Takeoff
1. Doors ..............................................................................LATCHED
2. CAPS Handle ..................................................Verify Pin Removed
3. Seat Belts and Shoulder Harness.................................... SECURE
4. Air Conditioner .......................................................... AS DESIRED
• Note •
If Air Conditioner is ON for takeoff roll, see Section 5,
Performance for takeoff distance change. No takeoff distance
change is necessary if system remains OFF for takeoff roll.
5. Fuel Quantity ................................................................. CONFIRM
6. Fuel Selector......................................................... FULLEST TANK
7. Fuel Pump ......................................................................... BOOST
8. Mixture ......................................................................... FULL RICH
9. Flaps ............................................................... SET 50% & CHECK
10. Transponder ............................................................................. SET
11. Autopilot ............................................................................. CHECK
12. Navigation Radios/GPS ......................................... SET for Takeoff
13. Cabin Heat/Defrost ................................................ AS REQUIRED
14. Brakes................................................................................... HOLD
15. Power Lever ................................................................... 1700 RPM
16. Alternator ........................................................................... CHECK
a. Pitot Heat.............................................................................ON
b. Navigation Lights .................................................................ON
c. Landing Light.......................................................................ON
d. Annunciator Lights....................................................... CHECK
Verify both ALT 1 and ALT 2 caution lights out and positive
amps indication for each alternator.
17. Voltage ............................................................................... CHECK
18. Pitot Heat ............................................................... AS REQUIRED
19. Navigation Lights ................................................... AS REQUIRED
20. Landing Light ......................................................... AS REQUIRED
(Continued on following page)
Revision 1