4-10 P/N 13772-003
Section 4 Cirrus Design
Normal Procedures SR22T
Starting Engine
1. External Power (If applicable) ....................................... CONNECT
2. Brakes .................................................................................. HOLD
3. Bat Master Switches ........................................... ON (Check Volts)
4. Strobe Lights ............................................................................. ON
5. Mixture ......................................................................... FULL RICH
6. Power Lever ........................................................FULL FORWARD
7. Fuel Pump.......................................................................... BOOST
8. Propeller Area .....................................................................CLEAR
9. Power Lever ........................................................... OPEN ¼ INCH
10. Ignition Switch ....................... START (Release after engine starts)
11. Mixture .................................................................................. LEAN
until RPM rises to a maximum value. Leave the mixture in this
position during taxi and until run-up.
12. Power Lever ..............................RETARD (to maintain 1000 RPM)
13. Oil Pressure ....................................................................... CHECK
14. Alt Master Switches .................................................................. ON
15. Avionics Power Switch .............................................................. ON
16. Engine Parameters ........................................................ MONITOR
17. External Power (If applicable) ................................. DISCONNECT
18. Amp Meter/Indication ......................................................... CHECK
Original Issue
To Next Page
Loading...
