3-8 P/N 13772-003
Section 3 Cirrus Design
Emergency Procedures SR22T
Engine Failure In Flight
1. Best Glide Speed ........................................................ ESTABLISH
2. Fuel Selector........................................................ SWITCH TANKS
3. Ignition Switch ........................................................ CHECK, BOTH
4. Fuel Pump......................................................................... BOOST
5. Power Lever ......................................................................½ OPEN
6. Mixture ...IDLE CUTOFF then slowly ADVANCE until engine starts
If engine does not start:
7.
Perform Engine Airstart or Forced Landing checklist, as required.
If engine starts:
8.
CHTs and Oil Temperature .............VERIFY within GREEN range,
warm engine at partial power if required.
Amplification
• WARNING •
If engine failure is accompanied by fuel fumes in the cockpit,
or if internal engine damage is suspected, move Mixture
Control to CUTOFF, Fuel Selector to OFF, and do not attempt
a restart.
If the engine fails at altitude, pitch as necessary to establish best glide
speed. While gliding toward a suitable landing area, attempt to identify
the cause of the failure and correct it. If altitude or terrain does not
permit a safe landing, CAPS deployment may be required. Refer to
Section 10, Safety Information, for CAPS deployment scenarios and
landing considerations.
Excessive engine cooling may be experienced during long descents
resulting in low engine oil and cylinder head temperatures. This may
result in the engine not accelerating properly when power is reapplied.
If oil or cylinder head temperatures are excessively low then the
engine should be operated at partial power until the temperatures are
sufficient for full power operation
Original Issue
To Next Page
Loading...
Need help?
General
