Using Basic Phone Functions
Using Phone Hardware and Accessories (Cisco SPA 303)
Cisco Small Business IP Phone SPA 30X User Guide (SIP) 36
3
Using Phone Hardware and Accessories (Cisco SPA 303)
Using the Speakerphone
To use the speakerphone, press the Speaker button (the handset can be either on
or off hook).
Using the Headset with Your IP Phone
Install the headset as described in the “(Optional) Connecting Wired and
Wireless Headsets” section on page 23.
NOTE Steps to use your headset with the IP phone may vary. Consult the user
documentation for your headset for more information.
Press the Headset button on your phone and dial the number to place a call, or
press the headset button to answer a ringing call.
Switching Between the Handset/Headset/Speakerphone
During a Call
Any of these audio devices can be used during a call. Only one device at a time
can be used.
The handset can be on the hook when using the speakerphone or headset
function. If switching from the handset to the speakerphone, make sure the
speakerphone or headset light is illuminated before placing the handset back on
the hook. (If you are switching from the handset to a wireless headset, however, do
not replace the handset or you will disconnect the call.)
Sending Audio to the Phone Speaker
Choosing this option sends audio to the speaker when the handset is lifted.
STEP 1 Press the Setup button.
STEP 2 Scroll to Preferences and press the select softkey.
STEP 3 Scroll to Send Audio to Speaker and press the edit softkey.
STEP 4 Press y/n to enable or disable the feature.
To Next Page
Loading...
Need help?
General
