EasyManuals Logo

Cisco 7925G User Manual

Cisco 7925G
176 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #144 background imageLoading...
Page #144 background image
c) Pair the charger and phone again.
Related Topics
Pair Charger and Wireless Phone, on page 119
Undock Phone
Procedure
To undock the phone, remove the phone from the cradle.
If you are on a call when you undock the phone, the Power/Bluetooth Status LED flashes blue while the Cisco
Unified Wireless IP Phone 7925G Desktop Charger disconnects. The call then continues on the phone.
Change Charger Speaker Volume
Procedure
Use the volume keys on the phone to raise or lower the speaker volume.
Charge Spare Battery
Use this procedure to install a spare battery so that it can be recharged. After the spare battery is fully charged,
you can use it as a power source (for a limited time) for the Cisco Unified Wireless IP Phone 7925G Desktop
Charger.
Prerequisites
The Cisco Unified Wireless IP Phone 7925G Desktop Charger must be plugged into the electrical outlet.
Procedure
Step 1
Insert the spare battery into the Cisco Unified Wireless IP Phone 7925G Desktop Charger as shown in the
following figure. The battery contacts must be facing the base of the charger.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G User Guide
122
Cisco Unified Wireless IP Phone 7925G Desktop Charger
Undock Phone

Table of Contents

Other manuals for Cisco 7925G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7925G and is the answer not in the manual?

Cisco 7925G Specifications

General IconGeneral
Keypad number of keys12
Display diagonal2 \
Display resolution176 x 220 pixels
Call waitingYes
Lines quantity6 lines
Voice codecsG.711a, G.722, G.729a, iLBC
Security algorithms128-bit WEP, SSL/TLS, WPA
Supported network protocolsDHCP, TFTP, DNS, SCCP, SRST
Input voltage100 - 240 V
Dimensions (WxDxH)52 x 20 x 127 mm
Minimum system requirementsCisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency50/60 Hz
Storage temperature (T-T)-30 - 60 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 95 %
Product typeIP Phone
Product colorGray
SafetyUL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standardsIEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e
Weight and Dimensions IconWeight and Dimensions
Weight138 g

Related product manuals