Cisco Catalyst 2960-XR - Where to Go Next; Additional References

PurposeCommand
Displays the RP routers associated with a sparse-mode multicast
group. This command is available in all software images.
show ip pim rp [group-name |
group-address]
Displays how the switch is doing Reverse-Path Forwarding
(that is, from the unicast routing table, DVMRP routing table,
or static mroutes).
show ip rpf {source-address | name}
Displays the Session Announcement Protocol (SAP) Version
2 cache.
show ip sap [group | session-name | detail]
Where to Go Next
You can configure the following for your IP multicast configuration:
•
IGMP feature support
•
PIM feature support
•
SSM feature support
•
IP Multicast Routing
Additional References
Related Documents
Document TitleRelated Topic
Catalyst 2960-XR Switch IP Multicast Command
Reference
For complete syntax and usage information for the
commands used in this book.
Standards and RFCs
TitleStandard/RFC
——
Catalyst 2960-XR Switch IP Multicast Routing Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29426-01 33
Configuring CGMP
Where to Go Next