Cisco Catalyst 2960-XR - Configuring Pimv2 BSR; (Optional) Saves Your Entries in the Configuration File

PurposeCommand or Action
•
For source, enter the multicast group address range for which the RP
should be used.
•
(Optional) For source-wildcard, enter the wildcard bits in dotted decimal
notation to be applied to the source. Place ones in the bit positions that
you want to ignore.
The access list is always terminated by an implicit deny statement for everything.
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 4
Verifies your entries.show running-config
Step 5
Example:
Switch# show running-config
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Step 6
Example:
Switch# copy running-config
startup-config
Related Topics
Example: Filtering Incoming RP Announcement Messages, on page 72
Configuring PIMv2 BSR
The process for configuring PIMv2 BSR may involve the following optional tasks:
•
Defining the PIM domain border
•
Defining the IP multicast boundary
•
Configuring candidate BSRs
•
Configuring candidate RPs
Catalyst 2960-XR Switch IP Multicast Routing Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29426-01 57
Configuring PIM
Configuring PIMv2 BSR