Cisco Catalyst 2960-XR - Adding Auto-RP to an Existing Sparse-Mode Cloud; Purpose

PurposeCommand or Action
Example:
Switch# show running-config
Displays active RPs that are cached with associated multicast routing entries.show ip pim rp mapping
Step 8
Example:
Switch# show ip pim rp mapping
Displays the information cached in the routing table.show ip pim rp
Step 9
Example:
Switch# show ip pim rp
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Step 10
Example:
Switch# copy running-config
startup-config
Related Topics
Auto-RP, on page 40
Example: Configuring Auto-RP, on page 72
Example: Defining the IP Multicast Boundary to Deny Auto-RP Information, on page 72
Example: Filtering Incoming RP Announcement Messages, on page 72
Adding Auto-RP to an Existing Sparse-Mode Cloud
This section contains suggestions for the initial deployment of Auto-RP into an existing sparse-mode cloud
to minimize disruption of the existing multicast infrastructure.
This procedure is optional.
Catalyst 2960-XR Switch IP Multicast Routing Configuration Guide, Cisco IOS Release 15.0(2)EX1
52 OL-29426-01
Configuring PIM
Configuring a Rendezvous Point