Cisco Catalyst 2960-XR Configuration Guides

CHAPTER 4
Configuring PIM
•
Finding Feature Information, page 35
•
Prerequisites for Configuring PIM, page 35
•
Restrictions for PIM, page 36
•
Information About PIM, page 37
•
How to Configure PIM, page 45
•
Monitoring PIM , page 69
•
Troubleshooting PIMv1 and PIMv2 Interoperability Problems, page 70
•
Configuration Examples for PIM, page 71
•
Where to Go Next, page 74
•
Additional References, page 74
•
Feature History and Information for PIM, page 75
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Configuring PIM
Prerequisites for Configuring PIM Stub Routing
The PIM stub routing feature supports multicast routing between the distribution layer and the access layer.
It supports two types of PIM interfaces, uplink PIM interfaces, and PIM passive interfaces. A routed interface
Catalyst 2960-XR Switch IP Multicast Routing Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29426-01 35

Cisco Catalyst 2960-XR Specifications

General

Stacking Bandwidth	80 Gbps
Layer Support	Layer 2 and Layer 3
Jumbo Frame Support	9198 bytes
RAM	512 MB
Input Voltage	100-240V AC
Model	Catalyst 2960-XR
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Downlink Interfaces	24 or 48 x Gigabit Ethernet ports
Power Supply	Internal
MAC Address Table Size	16, 000 entries
PoE	Available on PoE models
Weight	4.5 kg
Features	energy efficiency
Stacking	Up to 8 switches
Operating Temperature	0 to 45°C