Cisco Catalyst 2960-XR - Configuring Static Traffic Forwarding with SSM Mapping

PurposeCommand or Action
172.16.1.111 172.16.1.2
—
Repeat Step 5 to configure additional DNS servers for
redundancy, if required.
Step 6
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 7
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 8
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 9
startup-config
Related Topics
DNS-Based SSM Mapping, on page 81
Configuring Static Traffic Forwarding with SSM Mapping
Use static traffic forwarding with SSM mapping to statically forward SSM traffic for certain groups.
SUMMARY STEPS
1.
configure terminal
2.
interface type number
3.
ip igmp static-group group-address source ssm-map
4.
end
5.
show running-config
6.
copy running-config startup-config
Catalyst 2960-XR Switch IP Multicast Routing Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29426-01 87
Configuring SSM
Configuring Source Specific Multicast Mapping