Cisco Catalyst 2960-XR - Page 58

SUMMARY STEPS
1.
configure terminal
2.
interface interface-id
3.
ip pim passive
4.
end
5.
show ip pim interface
6.
show running-config
7.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Specifies the interface on which you want to enable PIM
stub routing, and enters interface configuration mode.
interface interface-id
Example:
Switch(config)# interface
Step 2
gigabitethernet 1/0/1
Configures the PIM stub feature on the interface.ip pim passive
Step 3
Example:
Switch(config-if)# ip pim passive
To disable PIM stub routing on an interface, use
the no ip pim passive interface configuration
command.
Note
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 4
(Optional) Displays the PIM stub that is enabled on each
interface.
show ip pim interface
Example:
Switch# show ip pim interface
Step 5
Catalyst 2960-XR Switch IP Multicast Routing Configuration Guide, Cisco IOS Release 15.0(2)EX1
46 OL-29426-01
Configuring PIM
Enabling PIM Stub Routing