Cisco Catalyst 9400

PurposeCommand or Action
that a duplicate of the username you are going
to create in the next step does not exist.
If you plan to use REST APIs for
CSLU-initiated retrieval of RUM reports, you
have to log in to CSLU. Duplicate usernames
may cause the feature to work incorrectly if
there are duplicate usernames in the system.
(Required) Establishes a username-based
authentication system.
username name privilege level password
password
Step 11
Example:
The privilege keyword sets the privilege level
for the user. A number between 0 and 15 that
specifies the privilege level for the user.
Device(config)# username admin privilege
15
password 0 lab
The password allows access to the name
argument. A password must be from 1 to 25
characters, can contain embedded spaces, and
must be the last option specified in the
username command.
This enables CSLU to use the product instance
native REST.
Enter this username and password
in CSLU (Collecting Usage
Reports: CSLU Initiated, on page
141 → Step 4. f. CSLU can then
collect RUM reports from the
product instance.
Note
Enters interface configuration mode and
specifies the Ethernet interface, subinterface,
or VLAN to be associated with the VRF.
interface interface-type-number
Example:
Device (config)# interface
gigabitethernet0/0
Step 12
Associates the VRF with the Layer 3 interface.
This command activates multiprotocol VRF
on an interface
vrf forwarding vrf-name
Example:
Device(config-if)# vrf forwarding
Mgmt-vrf
Step 13
Defines the IP address for the VRF.ip address ip-address mask
Example:
Step 14
Device(config-if)# ip address
192.168.0.1 255.255.0.0
Enables auto-negotiation operation for the
speed and duplex parameters of an interface.
negotiation auto
Example:
Step 15
Device(config-if)# negotiation auto
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
145
Smart Licensing Using Policy
Ensuring Network Reachability for CSLU-Initiated Communication