Cisco Catalyst 9400 User Manual

PurposeCommand or Action
• The CiscoTAC-1 profile is inactive. To
use this profile with the Call Home
service, you must enable the profile.
• The CiscoTAC-1 profile sends a full
report of all types of events subscribed in
the profile. The alternative is to
additionally configure
Device(cfg-call-home-profile)#
anonymous-reporting-only
anonymous-reporting-only. When this is
set, only crash, inventory, and test
messages will be sent.
Use the show call-home profile all command
to check the profile status.
Enables the destination profile.active
Example:
Step 9
Device(config-call-home-profile)# active
Enables the message transport method. In the
example, Call Home service is enabled via
HTTP and transport via email is disabled.
destination transport-method http{email
|http}
Example:
Step 10
The no form of the command disables the
method.
Device(config-call-home-profile)#
destination transport-method
http
AND
Device(config-call-home-profile)# no
destination transport-method
email
Configures the destination e-mail address or
URL to which Call Home messages are sent.
destination address { email email_address
|http url}
Step 11
When entering a destination URL, include
Example:
either http:// (default) or https://, depending
on whether the server is a secure server.
Device(config-call-home-profile)#
destination address http
https://tools.cisco.com/its/service/oddce/services/DDCEService
In the example provided here, a http://
destination URL is configured; and the no form
of the command is configured for https://.
AND
Device(config-call-home-profile)# no
destination address http
https://tools.cisco.com/its/service/oddce/services/DDCEService
Exits Call Home destination profile
configuration mode and returns to Call Home
configuration mode.
exit
Example:
Device(config-call-home-profile)# exit
Step 12
Exits Call Home configuration mode and
returns to privileged EXEC mode.
exit
Example:
Step 13
Device(config-call-home)# end
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
152
Smart Licensing Using Policy
Configuring the Call Home Service for Direct Cloud Access

Cisco Catalyst 9400 Specifications

General

Product Series	Catalyst 9400 Series
Layer	Layer 2/3
Operating System	Cisco IOS XE
Switch Type	Modular
Uplink Interfaces	10 Gigabit Ethernet, 40 Gigabit Ethernet, 100 Gigabit Ethernet
Stacking	No
Form Factor	Modular Chassis
Operating Temperature	0°C to 40°C (32°F to 104°F)
Redundancy	Power supplies
Security Features	MACsec
Management	Cisco DNA Center, CLI, SNMP