Usage Guidelines
Task groups are configured with a set of task IDs for each action type. Deleting a task group that is still
referenced in the system results in a warning and rejection of the deletion.
From global configuration mode, you can display all the configured task groups. However, you cannot display
all the configured task groups in taskgroup configuration mode.
Entering the taskgroup command with no keywords or arguments enters task group configuration mode, in
which you can use the description, inherit, show, and task commands.
Task ID
OperationsTask ID
read, writeaaa
Examples
The following example assigns read bgp permission to the task group named alpha:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# taskgroup alpha
RP/0/RP0/CPU0:router(config-tg)# task read bgp
Related Commands
DescriptionCommand
Creates a task group description in task configuration
mode.
description (AAA), on page 30
Adds a task ID to a task group.task, on page 107
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
110 OL-24740-01
Authentication, Authorization, and Accounting Commands
taskgroup
To Next Page
Loading...
