Cisco CRS User Manual

Telnet TFTP peer
RP/0/RP0/CPU0:router(config-telnettftp-peer)# address ipv4 10.1.0.0/16ipv6 33::33
Related Commands
DescriptionCommand
Configures an interface as an inband or out-of-band
interface to allow all peer addresses for a specified
protocol or all protocols.
allow, on page 166
Configures the control plane.control-plane, on page 169
Configures an inband interface or protocol.inband, on page 170
Configures a specific inband or out-of-band interface
or all inband or out-of-band interfaces.
interface (MPP), on page 172
Configures management plane protection to allow
and disallow protocols.
management-plane, on page 174
Configures out-of-band interfaces or protocols and
enters management plane protection out-of-band
configuration mode.
out-of-band, on page 175
Displays the management plane.show mgmt-plane, on page 177
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
OL-24740-01 165
Management Plane Protection Commands
address ipv4 (MPP)

Cisco CRS Specifications

General

Operating System	Cisco IOS XR
Product Type	Core Router
Form Factor	Modular Chassis
Dimensions	Varies by chassis type
Weight	Varies by chassis type
Architecture	Distributed
Switch Fabric	Multi-stage
Interface Support	Ethernet, SONET/SDH, OTN
Interfaces/Ports	Varies by line card
Port Density	Varies by line card
Routing Protocol	BGP, IS-IS, OSPF, MPLS
Management	CLI, SNMP
Power Supply	Redundant, hot-swappable
Cooling	Redundant, Hot-swappable Fan Trays
Supported Protocols	IPv4, IPv6, MPLS
Management Interfaces	Ethernet, console
Security Features	ACLs