Cisco CRS

The following example shows how to configure the VRF definition for MPP:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# control-plane
RP/0/RP0/CPU0:router(config-ctrl)# management-plane
RP/0/RP0/CPU0:router(config-mpp)# out-of-band
RP/0/RP0/CPU0:router(config-mpp-outband)# vrf my_out_of_band
Related Commands
DescriptionCommand
Configures the control plane.control-plane, on page 169
Configures a specific inband or out-of-band interface
or all inband or out-of-band interfaces.
interface (MPP), on page 172
Configures management plane protection to allow
and disallow protocols.
management-plane, on page 174
Configures out-of-band interfaces or protocols and
enters management plane protection out-of-band
configuration mode.
out-of-band, on page 175
Displays the management plane.show mgmt-plane, on page 177
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
180 OL-24740-01
Management Plane Protection Commands
vrf (MPP)