If the group command is used in administration configuration mode, only root-system and cisco-support
keywords can be specified.
Task ID
OperationsTask ID
read, writeaaa
Examples
The following example shows how to assign the user group operator to the user named user1:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# username user1
RP/0/RP0/CPU0:router(config-un)# group operator
Related Commands
DescriptionCommand
Creates a login password for a user.password (AAA), on page 44
Configures a user group and associates it with a set
of task groups.
usergroup, on page 117
Accesses username configuration mode, configures
a new user with a username, and establishes a
password and permissions for that user.
username, on page 119
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
OL-24740-01 33
Authentication, Authorization, and Accounting Commands
group (AAA)
To Next Page
Loading...
