Cisco CRS User Manual

Task ID
OperationsTask ID
read, writeaaa
Examples
The following example shows how to establish the unencrypted password pwd1 for user. The output from the
show command displays the password in its encrypted form.
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# username user1
RP/0/RP0/CPU0:router(config-un)# password 0 pwd1
RP/0/RP0/CPU0:router(config-un)# commit
RP/0/RP0/CPU0:router(config-un)# show running-config
Building configuration...
username user1
password 7 141B1309
Related Commands
DescriptionCommand
Adds a user to a group.group (AAA), on page 32
Accesses user group configuration mode and
configures a user group, associating it with a set of
task groups.
usergroup, on page 117
Accesses username configuration mode and
configures a new user with a username, establishing
a password and granting permissions for that user.
username, on page 119
Enters line template configuration mode for the
specified line template.
For more information, see the Cisco IOS XR System
Management Command Reference.
line
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
OL-24740-01 45
Authentication, Authorization, and Accounting Commands
password (AAA)

Cisco CRS Specifications

General

Operating System	Cisco IOS XR
Product Type	Core Router
Form Factor	Modular Chassis
Dimensions	Varies by chassis type
Weight	Varies by chassis type
Architecture	Distributed
Switch Fabric	Multi-stage
Interface Support	Ethernet, SONET/SDH, OTN
Interfaces/Ports	Varies by line card
Port Density	Varies by line card
Routing Protocol	BGP, IS-IS, OSPF, MPLS
Management	CLI, SNMP
Power Supply	Redundant, hot-swappable
Cooling	Redundant, Hot-swappable Fan Trays
Supported Protocols	IPv4, IPv6, MPLS
Management Interfaces	Ethernet, console
Security Features	ACLs