Examples
The following example shows how to establish the time for the dead-criteria conditions for a RADIUS server
to be marked as dead for the radius-server dead-criteria time command:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# radius-server dead-criteria time 5
Related Commands
DescriptionCommand
Specifies the number of consecutive timeouts that
must occur on the router before the RADIUS server
is marked as dead.
radius-server dead-criteria tries, on page 48
Defines the length of time, in minutes, for a RADIUS
server to remain marked dead.
radius-server deadtime , on page 50
Displays information for the dead-server detection
criteria.
show radius dead-criteria, on page 84
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
OL-24740-01 47
Authentication, Authorization, and Accounting Commands
radius-server dead-criteria time
To Next Page
Loading...
