Cisco MCS 7800 Series User Manual

A-32
Cisco TelePresence System Release 1.4 Administrator’s Guide
OL-12586-02
Appendix A Command Line Interface (CLI) Commands
show firewall list
show firewall list
show firewall list [detail | page | file name]
Syntax Description
Command Modes Admin
Command History
Usage Guidelines Use this command to display a list of current firewall port information.
Examples
admin:show firewall list
Chain INPUT (policy ACCEPT)
target prot opt source destination
DROP all -- localhost anywhere
ACCEPT udp -- anywhere anywhere udp dpt:syslog
DROP udp -- anywhere anywhere udp dpt:syslog
ACCEPT ipv6-crypt-- anywhere anywhere
ACCEPT icmp -- anywhere anywhere icmp echo-request limit: avg
10/sec burst 5
LOG icmp -- anywhere anywhere icmp echo-request limit: avg
1/min burst 5 LOG level warning prefix `ping flood '
DROP icmp -- anywhere anywhere icmp echo-request
DROP tcp -- anywhere anywhere tcp dpt:ftp
DROP udp -- anywhere anywhere udp dpt:ftp
DROP tcp -- anywhere anywhere tcp dpt:telnet
DROP udp -- anywhere anywhere udp dpt:telnet
DROP tcp -- anywhere anywhere tcp dpt:tftp
DROP tcp -- anywhere anywhere tcp dpt:gopher
DROP udp -- anywhere anywhere udp dpt:gopher
DROP tcp -- anywhere anywhere tcp dpt:finger
DROP udp -- anywhere anywhere udp dpt:finger
DROP udp -- anywhere anywhere udp dpt:http
DROP tcp -- anywhere anywhere tcp dpt:rtelnet
DROP udp -- anywhere anywhere udp dpt:rtelnet
DROP tcp -- anywhere anywhere tcp dpt:pop2
DROP udp -- anywhere anywhere udp dpt:pop2
DROP tcp -- anywhere anywhere tcp dpt:pop3
DROP udp -- anywhere anywhere udp dpt:pop3
DROP tcp -- anywhere anywhere tcp dpt:sunrpc
detail Shows details
page Pauses input after one page
file name Outputs the information to the indicated file name.
Note The file will be saved in platform/cli/fname.txt. Name should not
contain periods.
Release Modifications
1.1 This command was first documented.

Cisco MCS 7800 Series Specifications

General

Brand	Cisco
Model	MCS 7800 Series
Category	Switch
Language	English