CHAPTER
2-13
Cisco TelePresence Multipoint Switch Release 1.1 Administration Guide
OL-12586-02
2
Configuring Cisco Unified Communications
Manager for CTMS
Initial Release: May 5, 2008, OL-12586-02
Last Revised: August 4, 2008
Contents
• Overview, page 2-13
• Prerequisites, page 2-14
• Logging into the Unified CM Administration Application, page 2-14
• Creating a SIP Trunk Security Profile, page 2-14
• Creating a SIP Trunk, page 2-15
• Configuring a Route Pattern, page 2-16
• Configuring a Route Pattern, page 2-16
Overview
Before installing the CTMS Administration software on your Cisco MCS-7845 Media Convergence
Server, you need to perform the following configuration tasks in Cisco Unified Communications
Manager (Unified CM):
• Create a SIP security profile. This security profile will be used on the SIP trunk between CTMS and
Unified CM.
• Create a Session Initiation Protocol (SIP) trunk. The SIP trunk is used for communication between
Unified CM and CTMS.
• Create route patterns. A route pattern comprises a string of digits (an address) and a set of associated
digit manipulations that route calls to a route list or a gateway. Route patterns are used for routing
conferences numbers to the CTMS.
To Next Page
Loading...
Need help?
General
