Cisco MCS 7800 Series User Manual

6
Cisco TelePresence Multipoint Switch Release 1.1 Administration Guide
OL-12586-02
Preface
New in CTMS Release 1.1
New in CTMS Release 1.1
Increase in the Number of Supported Segments
CTMS Release 1.1 now supports up to 48 table segments (48 single-screen systems, 16 three-screen
systems, or a mix of both) in a single Cisco TelePresence conference.
Cisco TelePresence Interoperability With Legacy Video Conferencing Devices
Cisco TelePresence is based on open standards, including SIP, H.264. AAC-LD and G.711. With Cisco
TelePresence System (CTS) Release 1.3 and CTMS Release 1.1, Cisco TelePresence now supports
interoperability between Cisco TelePresence systems and traditional video conferencing/video
telephony endpoints using the Cisco Unified Video Conferencing 3500 series MCU (CUVC).
System Requirements
• Cisco MCS-7845-H2 or MCS-7845-I2 Media Convergence Server
• Cisco TelePresence Manager, Release 1.3
• Cisco Unified Communications Manager (Unified CM), Release 6.0 or later
• Cisco TelePresence System software, Release 1.3
• CTS-1000 and/or CTS-3000 systems
CTMS Administration Guide Organization
The CTMS Administration Guide is organized into the following chapters:
• Chapter 1: “Using CTMS Administration Software”
This section provides information about the CTMS Administration software interface
• Chapter 2: “Configuring Cisco Unified Communications Manager for CTMS”
This section provides instructions on how to configure Cisco Unified Communications Manager
(Unified CM) so that is supports CTMS functionality.
• Chapter 3: “Installing CTMS Administration Software”
This section describes how to install the CTMS administration software on the Cisco MCS-7800
Series Media Convergence Server.
• Chapter 4: “Configuring CTMS Administration Software”
This section provides information about configuring the initial CTMS system settings.
• Chapter 5: “Managing Meetings”
This section describe how to set up and administer static and ad hoc meetings using CTMS
Administration software.
• Chapter 6: “Monitoring CTMS System Processes”
This section describes how to monitor the CTMS system processes using the tools available in
CTMS.

Cisco MCS 7800 Series Specifications

General

Brand	Cisco
Model	MCS 7800 Series
Category	Switch
Language	English