A-46
Cisco TelePresence System Release 1.4 Administrator’s Guide
OL-12586-02
Appendix A Command Line Interface (CLI) Commands
show network route
show network route
show network route
Syntax Description None
Command Modes Admin
Command History
Usage Guidelines Use this command to display basic network route information.
Examples
admin:show network route
10.94.150.0/24 dev eth0 proto kernel scope link src 10.94.150.94
169.254.0.0/16 dev eth0 scope link
default via 10.94.150.1 dev eth0
Example with failover (NFT) enabled:
admin:show network route
10.94.150.0/24 dev bond0 proto kernel scope link src 10.94.150.98
10.94.150.0/24 dev eth0 proto kernel scope link src 10.94.150.98
10.94.150.0/24 dev eth1 proto kernel scope link src 10.94.150.98
169.254.0.0/16 dev bond0 scope link
default via 10.94.150.1 dev bond0
Related Commands
Release Modifications
1.1 This command was first documented.
Command Description
show network all Displays all show network command information
show network eth0 Displays basic Ethernet 0 platform network information
show network failover Displays NIC Teaming network fault tolerance information
show network
ip_conntrack
Retrieves the current utilization of ip_conntrack
show network
max_ip_conntrack
Retrieves the current ip_conntrack_max information
show network status Displays basic network status information
To Next Page
Loading...
Need help?
General
