Cisco MCS 7800 Series

A-42
Cisco TelePresence System Release 1.4 Administrator’s Guide
OL-12586-02
Appendix A Command Line Interface (CLI) Commands
show network eth0
show network eth0
show network eth0
Syntax Description None
Command Modes Admin
Command History
Usage Guidelines Use this command to display basic Ethernet 0 platform network information.
Examples
admin:show network eth0
Ethernet 0
DHCP : disabled Status : up
IP Address : 172.28.68.76 IP Mask : 255.255.252.0
Link Detected: yes Mode : Auto enabled, Full, 1000MB/s
Duplicate IP : no
DNS
Primary : 171.70.168.183 Secondary : 171.68.226.120
Options : timeout:5 attempts:2
Domain : cisco.com
Gateway : 172.28.68.1 on Ethernet 0
Related Commands
Release Modification
1.1 The command was first documented.
Command Description
show network all Displays all show network command information
show network failover Displays NIC Teaming network fault tolerance information
show network
ip_conntrack
Retrieves the current utilization of ip_conntrack
show network
max_ip_conntrack
Retrieves the current ip_conntrack_max information
show network route Displays basic network route information
show network status Displays basic network status information