Cisco PenTeleData 8800 Series Guide

• on
i,j
and off
i,j
are the on/off duration in seconds of a segment. i = 1 or 2, and j = 1 to 6.
• D
i
is the total duration of the section in seconds.
All durations can have up to three decimal places to provide 1 ms resolution. The wildcard character “*”
stands for infinite duration. The segments within a section are played in order and repeated until the total
duration is played.
Example 1:
60(2/4)
Number of Cadence Sections = 1
Cadence Section 1: Section Length = 60 s
Number of Segments = 1
Segment 1: On=2s, Off=4s
Total Ring Length = 60s
Example 2—Distinctive ring (short,short,short,long):
60(.2/.2,.2/.2,.2/.2,1/4)
Number of Cadence Sections = 1
Cadence Section 1: Section Length = 60s
Number of Segments = 4
Segment 1: On=0.2s, Off=0.2s
Segment 2: On=0.2s, Off=0.2s
Segment 3: On=0.2s, Off=0.2s
Segment 4: On=1.0s, Off=4.0s
Total Ring Length = 60s
• DialPlanScript—Scripting syntax that is used to specify Line 1 and Line 2 dial plans.
• Float<n>—A floating point value with up to n decimal places.
• FQDN—Fully Qualified Domain Name. It can contain up to 63 characters. Examples are as follows:
• sip.Cisco.com:5060 or 109.12.14.12:12345
• sip.Cisco.com or 109.12.14.12
• FreqScript—A miniscript that specifics the frequency and level parameters of a tone. Contains up to 127
characters.
Syntax: F
1
@L
1
[,F
2
@L
2
[,F
3
@L
3
[,F
4
@L
4
[,F
5
@L
5
[,F
6
@L
6
]]]]], where:
• F
1
–F
6
are frequency in Hz (unsigned integers only).
• L
1
–L
6
are corresponding levels in dBm (with up to one decimal place).
White spaces before and after the comma are allowed but not recommended.
Example 1—Call Waiting Tone:
440@-10
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
94
Cisco IP Phone Provisioning
Data Types

Cisco PenTeleData 8800 Series Specifications

General

Brand	Cisco
Model	PenTeleData 8800 Series
Category	IP Phone
Language	English