DescriptionParameter
AVT dynamic payload type for the 16 kHz clock rate.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<AVT_16kHz_Dynamic_Payload
ua="na">107</AVT_16kHz_Dynamic_Payload>
• In the phone web page, enter the payload.
Range: 96-127
Default: 107
AVT 16 kHz Dynamic Payload
AVT dynamic payload type for the 48 kHz clock rate.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<AVT_48kHz_Dynamic_Payload
ua="na">108</AVT_48kHz_Dynamic_Payload>
• In the phone web page, enter the payload.
Range: 96-127
Default: 108
AVT 48 kHz Dynamic Payload
Configure the SIP Settings for Extensions
Before you begin
Access the phone administration web page. See Access the Phone Web Interface, on page 104.
Procedure
Step 1 Select Voice > Ext(n), where n is an extension number.
Step 2 In the SIP Settings section, set the parameter values as described in the Parameters for SIP Settings on
Extensions, on page 366 table.
Step 3 Click Submit All Changes.
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
365
Cisco IP Phone Installation
Configure the SIP Settings for Extensions