Cisco PenTeleData 8800 Series Guide

Procedure
Step 1 Select Voice > SIP.
Step 2 In the SIP Timer Values section, set the SIP timer values in seconds as described in SIP Timer Values (sec),
on page 349.
Step 3 Click Submit All Changes.
SIP Timer Values (sec)
DescriptionParameter
RFC 3261 T1 value (RTT estimate) that can range
from 0 to 64 seconds.
Default: 0.5 seconds
SIP T1
RFC 3261 T2 value (maximum retransmit interval for
non-INVITE requests and INVITE responses) that
can range from 0 to 64 seconds.
Default: 4 seconds
SIP T2
RFC 3261 T4 value (maximum duration a message
remains in the network), which can range from 0 to
64 seconds.
Default: 5 seconds.
SIP T4
INVITE time-out value, which can range from 0 to
64 seconds.
Default: 16 seconds.
SIP Timer B
Non-INVITE time-out value, which can range from
0 to 64 seconds.
Default: 16 seconds.
SIP Timer F
INVITE final response, time-out value, which can
from 0 to 64 seconds.
Default: 16 seconds.
SIP Timer H
ACK hang-around time, which can range from 0 to
64 seconds.
Default: 16 seconds.
SIP Timer D
Non-INVITE response hang-around time, which can
range from 0 to 64 seconds.
Default: 16 seconds.
SIP Timer J
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
349
Cisco IP Phone Installation
SIP Timer Values (sec)

Cisco PenTeleData 8800 Series Specifications

General

Brand	Cisco
Model	PenTeleData 8800 Series
Category	IP Phone
Language	English