9,8,1[2-9]xxxxxxxxxS0 means that with the timer set to 0, the call is transmitted automatically when the user
dials the final digit in the sequence.
Edit the Dial Plan on the IP Phone
You can edit the dial plan in the XML configuration file. Locate the Dial_Plan_n_ parameter in the XML
configuration file, where n denotes the extension number. Edit the value of this parameter. The value must
be specified in the same format as in the Dial Plan field on the phone administration web page, described
below.
Note
Before you begin
Access the phone administration web page. See Access the Phone Web Interface, on page 104.
Procedure
Step 1 Select Voice > Ext(n), where n is an extension number.
Step 2 Scroll to the Dial Plan section.
Step 3 Enter the digit sequences in the Dial Plan field.
The default (US-based) systemwide dial plan appears automatically in the field.
Step 4 You can delete digit sequences, add digit sequences, or replace the entire dial plan with a new dial plan.
Separate each digit sequence with a pipe character, and enclose the entire set of digit sequences within
parentheses. Example:
(9,8<:1408>[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxx | 9,8,011xx. | 9,8,xx.|[1-8]xx)
Step 5 Click Submit All Changes.
The phone reboots.
Step 6 Verify that you can successfully complete a call with each digit sequence that you entered in the dial plan.
If you hear a reorder (fast busy) tone, review your entries and modify the dial plan appropriately.
Note
Regional Parameters Configuration
Regional Parameters
In the phone web user interface, use the Regional tab to configure regional and local settings, such as control
timer values, dictionary server script, language selection, and locale to change localization. The Regional tab
includes these sections:
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
400
Cisco IP Phone Installation
Edit the Dial Plan on the IP Phone
To Next Page
Loading...
Need help?
General