Cisco PenTeleData 8800 Series Guide

Table 66: IPv6 Address Settings Submenu
DescriptionDefaultField Type
or Choices
Field
Indicates whether the phone has Dynamic Host Configuration
Protocol (DHCP) enabled.
• DNS1—Identifies the primary DNS server that the phone
uses.
• DNS2—Identifies the secondary DNS server that the phone
uses.
• Broadcast Echo—Identifies if the phone responses to
multicast ICMPv6 message with destination address of
ff02::1.
• Auto config— Identifies if the phone uses automatic
configuration for the address.
DHCPConnection type
When DHCP is disabled, you must set the Internet Protocol (IP)
address of the phone and must set the values of the fields:
• Static IP—Identifies the IP that you assign to the phone. The
phone uses this IP address instead of acquiring an IP from
the DHCP server on the network.
• Prefix length—Identifies how many bits of a Global Unicast
IPv6 Address are there in the network part.
• Gateway—Identifies the default router used by the phone.
• Primary DNS—Identifies the primary DNS server that the
phone uses. When DHCP is disabled, you must set this field
manually.
• Secondary DNS—Identifies the primary DNS server that
the phone uses. When DHCP is disabled, you must set this
field manually.
• Broadcast Echo—Identifies if the phone responses to
multicast ICMPv6 message with destination address of
ff02::1.
Static IP
Text and Menu Entry From the Phone
When you edit the value of an option setting, follow these guidelines:
• Use the arrows on the navigation pad to highlight the field that you wish to edit. Press Select in the
navigation pad to activate the field. After the field is activated, you can enter values.
• Use the keys on the keypad to enter numbers and letters.
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
319
Cisco IP Phone Installation
Text and Menu Entry From the Phone

Cisco PenTeleData 8800 Series Specifications

General

Brand	Cisco
Model	PenTeleData 8800 Series
Category	IP Phone
Language	English