Cisco PenTeleData 8800 Series Guide

Before you begin
Access the Phone Web Interface, on page 104.
Procedure
Step 1 Select Voice > Ext(n), where (n) is the number of a phone extension.
Step 2 In the Call Feature Settings section, select the Default Ring parameter from the list or select no ring.
You can also configure this parameter in the configuration file (cfg.xml) by entering a string in this format:
<Default_Ring_3_ ua="rw">1</Default_Ring_3_>
Step 3 Select Voice > Phone.
Step 4 In the Ringtone section, set the Ring(n) and Silent Ring Duration parameters as described in the Parameters
for Ringtone, on page 174 table.
Step 5 Click Submit All Changes.
Parameters for Ringtone
The following table describes the parameters for Ringtone.
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
174
Cisco IP Phone Configuration
Parameters for Ringtone

Cisco PenTeleData 8800 Series Specifications

General

Brand	Cisco
Model	PenTeleData 8800 Series
Category	IP Phone
Language	English