Cisco PenTeleData 8800 Series Guide

Procedure
In a ring tone script, assign a name for the ring tone and add the script to configure a distinctive ringtone in
the format:
n=ring-tone-name;h=hint;w=waveform-id-or-path;c=cadence-id;b=break-time;t=total-time
where:
n = ring-tone-name that identifies this ring tone. This name appears on the Ring Tone menu of the phone. The
same name can be used in a SIP Alert-Info header in an inbound INVITE request to tell the phone to play the
corresponding ring tone. The name should contain the same characters allowed in a URL only.
h = hint used to SIP Alert-INFO rule.
w = waveform-id-or-path which is the index of the desired waveform to use in this ring tone. The built-in
waveforms are:
• 1 = Classic phone with mechanical bell
• 2 = Typical phone ring
• 3 = Classic ring tone
• 4 = Wide-band frequency sweep signal
You can also enter a network path (url) to download a ring tone data file from a server. Add the path in this
format:
w=[tftp://]hostname[:port]/path
c = is the index of the desired cadence to play the given waveform. 8 cadences (1–8) as defined in <Cadence
1> through <Cadence 8>. Cadence-id can be 0 If w=3,4, or an url. Setting c=0 implies the on-time is the
natural length of the ring tone file.
b = break-time that specifies the number of seconds to break between two bursts of ring tone, such as b=2.5.
t = total-time that specifies the total number of seconds to play the ring tone before it times out.
In the phone configuration XML file (cfg.xml), enter a string in this format:
<!-- Ringtone -->
<Ring1 ua="na">n=Sunrise;w=file://Sunrise.rwb;c=1</Ring1>
<Ring2 ua="na">n=Chirp 1;w=file://chirp1.raw;c=1</Ring2>
<Ring3 ua="na">n=Chirp 2;w=file://chirp2.raw;c=1</Ring3>
<Ring4 ua="na">n=Delight;w=file://Delight.rwb;c=1</Ring4>
<Ring5 ua="na">n=Evolve;w=file://Evolve.rwb;c=1</Ring5>
<Ring6 ua="na">n=Mellow;w=file://Mellow.rwb;c=1</Ring6>
<Ring7 ua="na">n=Mischief;w=file://Mischief.rwb;c=1</Ring7>
<Ring8 ua="na">n=Reflections;w=file://Reflections.rwb;c=1</Ring8>
<Ring9 ua="na">n=Ringer;w=file://Ringer.rwb;c=1</Ring9>
<Ring10 ua="na">n=Ascent;w=file://Ascent.rwb;c=1</Ring10>
<Ring11 ua="na">n=Are you there;w=file://AreYouThereF.raw;c=1</Ring11>
<Ring12 ua="na">n=Chime;w=file://Chime.raw;c=1</Ring12>
<Silent_Ring_Duration ua="na">60</Silent_Ring_Duration>
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
176
Cisco IP Phone Configuration
Add Distinctive Ringtone

Cisco PenTeleData 8800 Series Specifications

General

Brand	Cisco
Model	PenTeleData 8800 Series
Category	IP Phone
Language	English