Configuring Quality of Service (QoS)
Configuring Bandwidth Management
Cisco RV130/130W Wireless Multifunction VPN Router Administration Guide 111
7
STEP 4 Click Save.
Configuring Bandwidth Priority
In the Bandwidth Priority Table, you can assign priorities to services to manage
bandwidth usage.
To configure bandwidth priority:
STEP 1 In the Bandwidth Priority Table, click Add Row.
STEP 2 Enter information in the following fields:
Downstream The bandwidth (kb/s) used for receiving data from
the Internet. (Applies to the default VLAN only)
Enable Check to enable bandwidth management for this
service.
Direction Choose if you want to set priority for inbound or
outbound traffic.
Category Choose if you want to set bandwidth priority for a
service, VLAN/SSID, Source IP (inbound traffic), or
Destination IP (outbound traffic).
Service Choose the service to prioritize.
VLAN/SSID Choose the VLAN or SSID for which you want to
set priority.
IP Address If you select Source IP or Destination IP in the
Category field, enter the IP address and the subnet
mask of the source or destination.
Subnet Mask
Priority Set the priority (low, medium, or high) for the
selected category.
Remarking Check to enable remarking on Differentiated
Services Code Point (DSCP). Enabling this feature
prioritizes the network traffic across the LAN
based on the DSCP queue mapping on the DSCP
Settings page.
To Next Page
Loading...
