Cisco RV130 Administration Guide

3
Cisco RV130/RV130W Wireless Multifunction VPN Router Administration Guide 16
Configuring Networking
Configuring Wired WAN Connections
Configuring WAN properties for an IPv4 network differs depending on which type
of Internet connection you have.
Configuring DHCP (Automatic Configuration)
If your Internet Service Provider (ISP) uses Dynamic Host Control Protocol (DHCP)
to assign you an IP address, you receive an IP address that is dynamically
generated each time you log in.
To configure DHCP WAN settings:
STEP 1 Choose Networking > WAN.
STEP 2 From the Internet Connection Type drop-down list, choose Automatic
Configuration - DHCP.
STEP 3 From the DNS Server Source drop-down list, choose one of the following ways to
set the DNS server address:
• If you already have DNS server addresses from your ISP, choose Use these
DNS Servers, and enter the primary and secondary addresses.
• If you do not have DNS server addresses from your ISP, choose Get
Dynamically from ISP.
• To use the DNS servers provided by OpenDNS (208.67.222.222,
208.67.220.220) to resolve your web addresses, choose Use OpenDNS.
STEP 4 Click Save.

Cisco RV130 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1w, IEEE 802.3, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
Dual-band	No
Ethernet LAN (RJ-45) ports	4
Supported network protocols	PPPoE, PPTP, L2TP, DNS, IGMP, RSTP, NAT, PAT, SIP, ALG
Web-based management	-
Security algorithms	AES
Product color	Black
Certification	FCC, CE, IC
Input current	2 A
Output voltage	12 V
Power source type	DC
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Weight	- g