Cisco RV130 Administration Guide

Configuring Networking
Configuring LAN Settings
Cisco RV130/RV130W Wireless Multifunction VPN Router Administration Guide 31
3
If you enabled the device DHCP server, enter this information:
STEP 4 If you selected DHCP Relay, enter the address of the relay gateway in the Remote
DHCP Server field. The relay gateway transmits DHCP messages to network
device, including those on other subnetworks.
STEP 5 Click Save.
Disable Disables DHCP on the device when you want to manually
configure the IP addresses of all of your network devices.
DHCP Relay Relays the IP addresses assigned by another DHCP server to
the network devices.
Starting IP Address The first address in the IP address pool. Any DHCP
client joining the LAN is assigned an IP address in
this range.
Maximum Number of
DHCP Users
The maximum number of DHCP clients.
IP Address Range (Read-only) The range of IP addresses available to
the DHCP clients.
Client Lease time Duration (in hours) that IP addresses are leased to
clients.
Static DNS 1 IP address of the primary DNS server.
Static DNS 2 IP address of the secondary DNS server.
Static DNS 3 IP address of the tertiary DNS server.
WINS IP address of the primary WINS server.

Cisco RV130 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1w, IEEE 802.3, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
Dual-band	No
Ethernet LAN (RJ-45) ports	4
Supported network protocols	PPPoE, PPTP, L2TP, DNS, IGMP, RSTP, NAT, PAT, SIP, ALG
Web-based management	-
Security algorithms	AES
Product color	Black
Certification	FCC, CE, IC
Input current	2 A
Output voltage	12 V
Power source type	DC
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Weight	- g